Saturday, October 4, 2014

Introduced to the public in 1993, the Jeep Grand Cherokee is a mid-size SUV that is relatively easy to maintain. Like most automobiles, you can cut costs and fix some problems you may experience by yourself. One such issue you may come across is having corroded or cracked windshield-washer tubing.

Instructions

    1

    Check to make sure the windshield-washer tubing isn't clogged. Sometimes the tubing doesn't need to be replaced. If the little holes on the ball of the sprayer become clogged from hard water or build-up from the washer fluid, take a pin or sewing needle, and poke a hole to get rid of any debris.

    2

    Purchase windshield-washer tubing from a car parts store. The tubing might also be referred to as vacuum tubing.

    3

    Locate the old tubing, which should be next to the windshield-washer fluid reservoir. You can find that near the front right corner of the engine compartment. Depending on when your Grand Cherokee was manufactured, the reservoir may have a black or a yellow cap.

    4

    Remove the old tubing. Be careful around the vacuum connectors. Try not to break or disfigure them if you plan to reuse them.

    5

    Hold up the old windshield-washer tubing if you plan to replace the entire section. Place the new tubing next to the old, using the old as a guide to the length your Grand Cherokee needs. Use a hose cutter to cut enough of the new tubing to fit your Jeep Grand Cherokee.

    6

    Place the new tubing in your Grand Cherokee. Use the old connectors, or insert the new ones, and ensure the tubing doesn't interfere with any other engine parts. When closing the hood, be extra cautious to make sure the tubing doesn't get bent.

0 comments:

Post a Comment