How to Replace the Water Hoses in a VW Passat

Volkswagens are some of the safest vehicles around, and a Passat serves that purpose well. Families feel confident in their choice of the Passat to carry their precious cargo. You can even maintain it yourself, since it's very user-friendly. Use these instructions to replace the water hoses in a 2000 to 2007 VW Passat every 3 years, or when you start to see wear.

Instructions

Remove Old Hoses

1

Choose the hoses that fit your VW Passat at your local auto parts store. There are three necessary here. Gates preformed hoses are a good choice; look for items 22875 (upper radiator to tee), 22876 (tee to engine) and 22808 (lower), or use comparable hoses if these aren't available.

2

Loosen the old clamps by turning the tension-controlling screw left with a flathead screwdriver. Use a pair of pliers to squeeze the tension spring clamp and move it to a more pliable area of the hose so it's out of the way.

3

Mark how high the old hose comes on the machinery, so you can put the replacement up the same amount and avoid leakage. Take a digital picture of the original placement so you can replicate it.

4

Slit the hose downward a couple of inches below the insertion point and peel it away, as needed. Use a piece of coarse sandpaper to clean the area where the hose was stuck to the VW Passat. Clean the other connection areas while they're free.

5

Jack up the VW Passat one side at a time, put jack stands in place and let the car down on the stands. Position a container below the radiator to catch the coolant mixture so it doesn't go into the storm drains and thus the groundwater. Open the drain plug or remove the bottom radiator hose to drain.

6

Remove the top hose by slipping it off the radiator shroud at one end and the thermostat housing at the other. Discard all the used hoses and clamps. Sand the areas where the old hose met the VW Passat parts to remove pieces of hose and other grit.

Install New Hoses

7

Use adjustable clamps with screws for greater protection in holding the new hoses in place. Install the new VW Passat hoses by reversing the steps you went through when removing the old ones.

8

Place the clamps on the top hose and slide them toward the middle. Push the hose securely onto the top opening in the radiator shroud at one end and the thermostat housing (at the top of the water pump) on the other. Tighten each clamp by tightening the screw.

9

Repeat the above step for the clamps and connect the next hose to the bottom radiator shroud at one end and the bottom of the engine at the other. Adjust clamps into place and tighten the screws. Close the radiator drain plug, if applicable.

10

Fill the radiator with a 50/50 combination of coolant and water to the cap line. Add more as it goes down into the radiator. Do this until it stops percolating and making room for more coolant.

11

Start the VW Passat's engine with the radiator cap off. The thermostat will get warmer, and the fluid will drop as the coolant begins to circulate. Finish filling the radiator, if needed. Put the radiator cap back on and fill up the overflow reservoir to the "full" line.

12

Check to see that the temperature gauge is no higher than before. Verify the drain plug is closed and there are no leaks at the hose connections or anywhere else.