The wheel hub is where the brakes and the actual wheel are mounted on the rear end of the Ford Taurus. On the 2000 model, the hub is connected to the wheel bearings, which are sealed and don't require maintenance. You need to replace the hub if the attached bearing assembly becomes noisy or develops excessive play. You will need plenty of garage space to perform maintenance of this caliber, and you should talk with your mechanic first.
Instructions
- 1
Raise the car's rear end and support it on jack stands, then block the front wheels and remove the rear wheel for the hub you are removing.
2Remove the brake caliper if the rear wheels have brake discs by removing its bolts with a wrench, then unbolt and remove the caliper mounting bracket and slip the brake disc off the studs. Pull off the brake drum if the wheels use drum brakes.
3Remove and discard the grease cap from the center of the hub. Remove and discard the hub's retaining nut with a wrench and remove the hub and bearing assembly from the spindle.
4Connect the replacement hub to the spindle and apply a new retaining nut, tightening it to between 188 and 254 foot-pounds. Install a new grease cap.
5Reconnect the brake drum or brake disc with its caliper and mounting bracket, then reconnect the wheels and lower the car.
6Pump the brake pedal several times to reseat the brake pads or shoes.
0 comments:
Post a Comment