How to Replace the Ignition Coil in a Dodge Intrepid

Even though Dodge uses a distributorless ignition system, or direct ignition system, it still has an ignition coil. You can find the ignition coil for a Dodge Intrepid inside the ignition coil pack, which contains three independent ignition coils. Each coil fires two cylinders.

Instructions

1

Lift the hood of the Dodge Intrepid and locate the ignition coil pack. You should see it attached to the left cylinder head.

2

Prevent injury by disconnecting the negative cable from the battery. For added safety, consider wrapping the end of the cable in a cloth to prohibit an accidental connection. You should also set your emergency brake.

3

Label the coil wires with masking tape, and then unplug them from the ignition coil pack. Unhook the electrical wiring harness connector from the ignition coil pack.

4

Remove the mounting screws for the ignition coil pack with a screwdriver. Slide the coil pack under the mounting bracket to remove it.

5

Isolate the ignition coil you want to remove. Loosen and remove any fasteners that hold it in place.

6

Put the new Dodge Intrepid ignition coil back in the coil pack and reassemble the parts. If you have a Torque wrench, tighten the mounting screws with 9 foot pounds of torque (12 Nm).